How to Reset Sony Car Stereo Without Reset Button

If your Sony car stereo is not working properly, you may need to reset it. To do this, you will need to disconnect the battery and then reconnect it. Once the battery is reconnected, press and hold the reset button for about five seconds.

  • Locate the reset button on your Sony car stereo
  • This is usually located on the faceplate of the unit, but it may also be located on the rear of the unit or in the glove compartment
  • If you cannot find the reset button, consult your Sony car stereo’s owners manual for its location
  • Press and hold the reset button for three to five seconds to reset your Sony car stereo
  • The unit will reboot itself and should return to its factory settings
How to Reset Sony Car Stereo Without Reset Button



How Do I Hard Reset My Car Radio?

If you’re looking to hard reset your car radio, there are a few things you’ll need to do. First, locate the fuse box in your vehicle and find the fuse that corresponds to your radio. Once you’ve found it, remove the fuse and then disconnect your battery.

Next, press and hold the power button on your radio for 30 seconds. After that, reconnect your battery and insert the fuse back into its slot. Finally, turn on your radio and see if it’s working properly.

If not, repeat these steps until it does.

Why Won’t My Sony Car Stereo Turn On?

If your Sony car stereo won’t turn on, there are a few possible explanations. First, check to make sure that the unit is properly plugged into the power outlet. If it is, then the problem may be with the unit itself and you’ll need to take it to a Sony service center for repairs.

It’s also possible that there’s an issue with your car’s electrical system; if this is the case, you’ll need to take it to a mechanic for diagnosis and repair. In rare cases, a blown fuse in your car’s fuse box can cause your Sony car stereo to stop working; if this happens, simply replace the fuse and see if that solves the problem.

How Do I Factory Reset My Sony Music System?

If your Sony music system is not working properly, you may need to reset it to its factory settings. This will erase all of your custom settings and return the system to its default state. To do this, follow these steps:

1. Unplug the power cord from the AC outlet and disconnect any other cables connected to the system.

2. Press and hold down the “RESET” button on the back of the unit for more than 5 seconds.

3. While holding down the “RESET” button, plug in the power cord to the AC outlet. Continue to hold down the “RESET” button until you hear a beep from the unit (this should take about 10 seconds).

4. Once you hear the beep, release the “RESET” button and your Sony music system will now be reset to its factory settings!

How Do I Reset My Sony Bluetooth Stereo?

If your Sony Bluetooth stereo is not working properly, you may need to reset it. Here’s how to do it:

1. Turn off the power to the stereo.

2. Unplug the stereo from the AC outlet.

3. Press and hold the “reset” button on the back of the stereo for about 5 seconds. The “reset” button is usually small and red, and is located near the bottom of the unit.

4. Plug the stereo back into the AC outlet and turn on the power. The stereo should now be reset and working properly.

How to Sony car stereo reset!! music system reset?

How to Reset Car Radio to Factory Settings

If you’ve ever had your car radio act up on you, or if you’ve ever bought a used car and wanted to reset the radio to factory settings, then this guide is for you. Resetting your car radio is a pretty simple process, and it only takes a few minutes to do.First, locate the fuse box in your car.

It’s usually located under the dash on the driver’s side. Once you’ve found it, look for the fuse that says “Radio” or “Audio.” This is the fuse that controls power to the radio.

Pull it out and take a look at it. If it’s blown, replace it with a new one of the same amperage.Now that the power is back on, locate the button labeled “Reset” or “Memory.”

This button will be located somewhere on your radio. Press and hold this button until you hear a beep or see a message on the display indicating that the memory has been erased. You may need to consult your owner’s manual for specific instructions on how to do this for your particular model of car radio.

And that’s all there is to it! Once you’ve reset your car radio, all of your presets will be erased and you’ll be able to start fresh with new ones.


If your Sony car stereo is giving you trouble, you may be able to reset it without using the reset button. First, disconnect the negative battery terminal. Then, press and hold the power button for at least 15 seconds.

This should reset the unit. If it doesn’t work, try pressing and holding the power button while simultaneously pressing the eject button.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Scroll to Top