How to Get Rid of Engine Noise in Car Stereo

If your car stereo is picking up engine noise, there are a few things you can try to eliminate it. First, check all of your connections and make sure they are tight. If that doesn’t work, you can try adding ground loop isolators to your RCA cables.

You can also try running a separate ground wire from your head unit to the chassis of your car. If none of those solutions work, you may need to replace your head unit with one that has better noise isolation circuitry.

  • If you have a car with an engine noise, there are a few things that you can do to try and get rid of it
  • One thing that you can do is to turn up the volume on your car stereo
  • This will help to mask the engine noise and make it less noticeable
  • Another thing that you can do is to change the way that you listen to your music
  • If you typically listen to music at a low volume, try turning it up a bit so that the engine noise is not as noticeable
  • You can also try changing the type of music that you listen to in your car
  • If you typically listen to rock or metal, try switching to something with a softer sound so that the engine noise is not as jarring
  • Finally, if all else fails, you can always take your car in for service and have them look at the source of the engine noise to see if there is anything that can be done about it


What Causes Engine Noise in Speakers?

If you’re hearing engine noise coming from your speakers, there are a few possible causes. The first is that your amplifier is picking up interference from your car’s engine. This can happen if the amp is mounted near the engine, or if it’s not properly shielded.

Another possibility is that your speaker wires are picking up interference from other electrical sources in your car, like the alternator or power windows. If you have aftermarket stereo equipment installed, it could also be the source of the noise. To fix this problem, you’ll need to isolate and identify the source of the interference and then take steps to eliminate it.

How Do You Reduce Engine Noise?

There are a few ways to reduce engine noise. One way is to use sound proofing materials to line the engine compartment. This will help to absorb some of the noise.

Another way is to use a muffler or exhaust system that is designed to quiet the engine noise. Finally, you can tune the engine so that it runs more smoothly and quietly.

Why Does My Car Stereo Make a Buzzing Sound When I Accelerate?

If your car stereo is making a buzzing sound when you accelerate, it could be caused by a few different things. One possibility is that your car’s alternator is going bad. When an alternator starts to fail, it can cause all sorts of electrical problems, including making a buzzing sound.

Another possibility is that there’s something wrong with your car’s electrical system. If there’s a loose connection somewhere, it can cause a buzzing sound. Finally, it could just be that your car stereo is old and needs to be replaced.

If the buzzing sound is only happening when you accelerate, it’s likely due to an alternator or electrical problem. But if the sound happens all the time, even when you’re not accelerating, then it’s probably time for a new stereo.

Car audio FIX! Ground and engine noise solution.

Diy Car Audio Noise Filter

If you’re looking for a way to reduce the amount of noise in your car audio system, a DIY car audio noise filter may be the answer. There are a few different ways to build one of these filters, but they all essentially work by filtering out unwanted noise from the audio signal.One popular method is to use an inductor and capacitor in series.

The inductor acts as a low-pass filter, while the capacitor blocks high-frequency noise. Another approach is to use a resistor and capacitor in parallel. This configuration filters out both low and high frequencies, but it’s more difficult to implement.

Whichever method you choose, building your own car audio noise filter is a relatively simple project that can make a big difference in the quality of your sound system.


Are you bothered by the engine noise in your car stereo? If so, there are a few things you can do to get rid of it. First, make sure that your car stereo is properly grounded.

If it isn’t, the engine noise will be amplified. Second, use a noise filter. Noise filters are designed to reduce engine noise and other unwanted noises from your car stereo.

Third, use an equalizer to adjust the sound of your car stereo. This will help to balance out the bass and treble so that the engine noise is less noticeable. Finally, if all else fails, you can always turn up the volume!

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Scroll to Top